Ground support GSE GROUNDSYSTEM
9th October, 2023Victron MultiPlus II GX 48/3000 / 35-32
9th October, 2023Smartsolar MPPT Victron 75/15 - 100/20
99,60€ - 170,40€
Smartsolar MPPT 75/15 - 100/20
When a solar charge controller cannot fully charge the battery in one day.
This often results in the battery constantly alternating between a “partially charged” state and an “end of discharge” state.
This operating mode (non-regular full recharge) will damage lead-acid batteries in a few weeks or months.
The BatteryLife algorithm monitors the state of charge of the battery, and if necessary, increases it slightly, day after day the level of disconnection of the load (i.e. it disconnects the load earlier), until the solar energy produced is sufficient to recharge the battery to almost 100% of its capacity.
From there, the load disconnect level will be modulated so that almost 100% recharge is achieved at least once a week
Smartsolar MPPT Victron 75/15 - 100/20
A solar charger collects energy from your solar panels, and stores it in your batteries.
Using the latest and fastest technology, the SmartSolar maximizes this “harvest” of energy, managing it intelligently so as to achieve full charge as quickly as possible.
The SmartSolar keeps your battery in good condition and extends its lifespan.
MPPT: ultra fast location of the maximum power point.
The MPPT constantly monitors the voltage and current output of your solar panels (PV).
MPPT technology ensures that every particle of energy available from your panels is collected for storage.
The advantage of this technology is appreciated when the sky is cloudy, and the intensity of the light constantly changes.
Remote monitoring and control
Remotely control and supervise the multiple functions of your SmartSolar MPPT charger by connecting Bluetooth and associating it with your smartphone through VictronConnect.
If your installation is connected to the internet:
- Victron's remote management portal (VRM) allows you to access the full power of your MPPT,
For remote installations:
- without an internet connection or a nearby telephone signal, you may be able to monitor your MPPT by pairing it via Bluetooth with a device with the technology LoRaWAN(extended long range network), available as an option.
Charge output
The intelligent charge output function avoids the risk of damage caused by using “dead” batteries.
You can configure the voltage at which the SmartSolar will disconnect a charge if necessary, thereby preventing excessive drawing on your batteries.
And here is the most interesting:
- SmartSolar will try to achieve 100% recharge every day.
- If this is not possible, for example during periods of bad weather,
- it will increase the disconnection voltage, daily, until full recharge.
- We call this function BatteryLife because it keeps your battery in good condition and extends its service life.
Model: | 75 / 15, 100 / 20 |
---|